• gary@cheowseng.com
  • +86-769-88755330-816/830
Image

This Is How You Use The Self – Tapping Screw!

This Is How You Use The Self – Tapping Screw!

As the name of the product implies, self–tapping screws have their drill bit, so there’s no need to drill a hole before using a self-tapping screw as it’s designed to go through metals, so it’s best for exhausting hat shields.

In his blog post, you will learn how to install a self-tapping sheet metal screw. Let’s get started!

How to install a Self-Tapping metal sheet?

If you take a simple self-tapping screw, then you will see it has a little drill bit on a tip that drills the right size hole, so that screw can cut threads into the sheet metal.

First thing, make sure you’re using a proper bit. Experts usually prefer number two Philips, if you use number one Phillip self-tapping screw, then it might wobble terribly that you won’t be able to keep it in the saddle. And, if you used the third number screw, then it won’t even begin to fit in the screw

Secondly, it’s also must sure your second number self-tapping screw doesn’t have a bunch of filing stuck to it. These holders are magnetic and can capture any kind of metal flakes or filings, usually, you can just wipe them off with our fingers. Though not perfect, but good enough to get the screw to seat on it a good fit. The magnet should hold it on petty securely, you can also use the Philips bit without a magnetic bit holder, but these help hold the screw, so they make it quite easier

Make sure, you drill is neither forward, nor reverse. Press the screw steadfastly at the preferred location, and pull the trigger gently. Don’t start with full speed unless you don’t get tour de force command over it. Make sure it doesn’t rotate or quit from the destined location.

If it tries to I back on the desired spot, then press a little harder, start slowly to let it start drilling the hole in the right place, or at times it’s just a bad screw so try another one. As it starts drilling, then cut the hole, now you can go ahead, and provide more gas.

Sped up typically, you’ll be fasting the two pieces together with this screw, so it’s imperative to clamp the two pieces, or hold together pretty tightly, otherwise, when the screw gets through the first layer, I will try pushing the second layer away as it threads into the first layer, so clamp them together, this will have to drill through the second piece before it reaches the thread and the first layer pushes them apart

Now, screw it uptight, not overtight that it strips out the thread and just spins freely. When it gets over tight, then it results in losing an optimum strength, you should know when to stop when it gets tight. If you’re using a cordless drill, so it comes with a clutch, you can set to prevent stripping, just make sure you set it high enough to screw it tight. Sometimes after I drill the hole, and starts to thread, you may want to begin feathering the trigger to bring it to a tight fit

Now, that’s a perfect fit self-tapping sheet metal screw. For better assistance, consult any reliable self-tapping screw fastener manufacturer or supplier near your own.

Inquire Now